9/25/2023 0 Comments Lt4 hot cam vortec 350![]() ![]() So I can get this combo up and running? I have built an ALDL cable interface to data log once I get it up and running. I am reworking my wiring harness to remove all the pollution equipment, rear 02 sensorsĭoes anyone have a tune for a 元1 Vortec 350 running a mild cam and headers that would get me close I’m going to run the LT4 “Hot Cam” with 1.6 rockers, long tube headers and 24.lb per hour blue top fuel injectors, a Truck MAF and stock Map sensor I have built a 383 Stroker LT1 engine for my car with ported Factory aluminum heads that have been milled, should be good for 11.5 compression. The rest is just “Re-pinning” of the harness to the new PCM. Position sensor in the timing chain cover,I’ve already got most of the necessary pieces on hand. Since my ‘96 has the reluctor wheel/ crankshaft The dizzy willįunction as just that, a cap and rotor to fire the plugs. I am in the process of converting my ‘96 Trans Am to a 0411 PCM, basically, going to eliminate theĮlectronics of the LT1 “Optispark” distributor by wiring the engine as a 元1 Vortec 350. I have used a LT4 Hot Cam in my Vortec 350 and it did go pretty good, the only reason I took it out was I had a vibration in 6th gear that I thought was the engine being lugged. 200 and lower lift range that a flat tappet cannot do. I want to open up by saying I’m very impressed by the knowledge and experience shown Ya, you can clone an LT4 Hot Cam but it will not perform as good because the roller cam is so much better at the. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |